Juniper MX2010 Hardware Manual page 274

Universal routing platform

Hide thumbs Also See for MX2010:

Table of Contents

Figure 99: Installing the MX2010 Router on an Open-Frame Rack

12. With four people pushing on the front-mounting flanges, slide the router until the center-mounting

brackets (open-frame racks) or front-mounting flanges (four-post racks) contact the rack rails. In a

four-post rack, the mounting shelf ensures that the holes in the front-mounting flanges of the chassis

align with the holes in the rack rails.

13. Move the pallet jack away from the rack.

14. Insert twelve mounting screws (six on each side) into the mounting holes to secure the router to the

15. Visually inspect the alignment of the router. If the router is installed properly in the rack, all the mounting

screws on one side of the rack should be aligned with the mounting screws on the opposite side, and

the router should be level.

Table of Contents

Troubleshooting