Juniper MX2010 Hardware Manual page 447

Table 94: Tools and Parts Required for Component Replacement (continued)
Components
DC power distribution module
DC power supply cable
Fan trays (upper and lower)
Air Baffle
MPC
MIC
Routing Engine and Control Board
(CB-RE)
Tool or Part
Phillips (+) screwdrivers, numbers 1 and 2
7/16-in. (11 mm) hexagonal-head external drive socket
wrench, or nut driver, with a torque range between
23 lb-in. (2.6 Nm) and 25 lb-in. (2.8 Nm) to attach the
ground wire.
1/4-in. slotted screwdriver and 5/32-in. (4 mm) Allen
wrench to attach input terminal wires of the AC power
cord.
7/16-in. (11 mm) nut driver or socket wrench
CAUTION: You must use an appropriate
torque-controlled tool to tighten the nuts. Apply
excessive torque damages the terminal studs and the
PDM. The absolute maximum that may be applied to
this nut is between 23 lb-in. (2.6 Nm) and 25 lb-in.
(2.8 Nm).
Phillips (+) screwdrivers, numbers 1 and 2
Phillips (+) screwdrivers, numbers 1 and 2
Phillips (+) screwdrivers, numbers 1 and 2
Blank panels (if component is not reinstalled)
Electrostatic bag or antistatic mat
Phillips (+) screwdrivers, numbers 1 and 2
Rubber safety cap for fiber-optic MICs
Flat-blade (–) screwdriver
Electrostatic bag or antistatic mat
Blank panels (if component is not reinstalled)
Phillips (+) screwdrivers, numbers 1 and 2
Electrostatic discharge (ESD) grounding wrist strap
Blank panels (if component is not reinstalled)
431