Juniper MX2010 Hardware Manual page 710

9. Remove the router from the rack:
Install the pallet jack attachment to a pallet jack. Position the pallet jack in front of the rack, and
unscrew and remove the mounting screws from the rack.
NOTE:
pallet jack is approximately 48 in. (121.92 cm) deep and 27 in. (68.58 cm) wide.
A minimum of four people can then slide the router onto the pallet jack by using the handles on the
shipping covers. Attach the four shipping brackets and hardware to the pallet jack attachment.
Securing the brackets to the router chassis.
Position the router in front of the shipping crate and raise the pallet jack.
Remove the shipping brackets and hardware and set aside.
10. Place the router in the shipping crate or onto the pallet. If on a pallet, bolt the router to the pallet.
11. Re-attach the shipping brackets to the router chassis and the pallet.
12. Cover the router with an ESD bag and place the packing foam on top of and around the router.
13. Replace the accessory box on top of the packing foam.
14. Securely place the crate cover over the router.
15. Close all latches to secure the shipping crate to the pallet.
16. Write the RMA number on the exterior of the box to ensure proper tracking.
RELATED DOCUMENTATION
Preventing Electrostatic Discharge Damage to an MX Series Router
Powering Off the DC-Powered MX2000 Router | 698
Replacing an MX2010 Three-Phase Delta AC Power Cord | 563
The pallet jack attachment fits only on a standard pallet jack. The standard
WARNING: Juniper Networks recommends using a pallet jack with the
attachment. Not using a pallet jack with the attachment can result in personal
injury and can damage to the equipment.
695