Juniper MX2010 Hardware Manual page 10

Mapping Input Power from AC Power Distribution Modules to AC Power Supply Modules on
MX2000 Routers | 302
Connecting Power to a DC-Powered MX2010 Router with Power Distribution Modules (-48
V) | 304
Connecting Power to a DC-Powered MX2000 Router with DC Power Distribution Modules (240
V China) | 309
Connecting an MX2000 DC Router Power Distribution Module (-48 V) Cable | 310
Connecting an MX2000 DC Router Power Distribution Module (240 V China) Cable | 313
Powering On the DC-Powered MX2010 Router | 315
Powering On the DC-Powered (240 V China) MX2000 Router | 317
Powering On a Three-Phase AC-Powered MX2000 Router | 319
Troubleshooting the MX2000 Router Power System | 320
Connecting the Router to the Network | 337
Connecting the MX2010 Router to Management and Alarm Devices | 337
Connecting the MX2010 Router to a Network for Out-of-Band Management | 337
Connecting an MX2000 Router to a Console or Auxiliary Device | 338
Connecting an MX2010 Router to an External Alarm-Reporting Device | 340
Connecting the MX2010 Router to a Network for Out-of-Band Management | 342
Connecting an MX2000 Router to a Console or Auxiliary Device | 343
Connecting an MX2010 Router to an External Alarm-Reporting Device | 344
Connecting the Alarm Relay Wires to the MX2010 Craft Interface | 346
Disconnecting the Alarm Relay Wires from the MX2010 Craft Interface | 347
Connecting MPC or MIC Cables to the MX2010 Router | 348
Initially Configuring the Router | 351
Initially Configuring the MX2010 Router | 351
Installing and Replacing Components
4
Installing Components | 359
Installing an MX2010 Adapter Card | 360
Installing the MX2010 Air Filter | 361
Installing the MX2010 Craft Interface | 366
Installing the MX2010 Standard DC Cable Manager | 368
Installing an MX2000 Router DC Power Distribution Module (-48 V) | 370
Installing an MX2000 Router DC Power Distribution Module (240 V China) | 372
x