Juniper MX2010 Hardware Manual page 282

3. Install the winch mount bracket to the rear rack rails by using the six captive screws, and tighten the
screws (see Figure 105 on page
Figure 105: Installing Winch Mount Bracket to Rack Rails
4. Adjust the height of the router by turning the handles clockwise until the router transport platform is
aligned with the surface of the mounting shelf and slightly higher than the mounting shelf (see
Figure 106 on page 266).
NOTE: Make sure the bubbles within the T-shaped levels are between the lines, indicating
that the router is level.
5. Adjust the four leveling mounts on the router transport platform until all four leveling mounts rest
firmly on the ground (see
265).
Figure 106 on page 266).
265