Juniper MX2010 Hardware Manual page 11

Installing an MX2010 DC Power Supply Module (-48 V) | 375
Installing MX2000 Router DC Power Supply Modules (240 V China) | 376
Installing an MX2010 Dual-Wide MIC | 380
Installing the MX2010 Standard EMI Cover | 382
Installing the MX2010 Extended EMI Cover | 383
Installing an MX2010 Fan Tray | 385
Installing the MX2010 Air Baffle | 387
Installing the MX2010 Standard Cable Manager | 388
Installing the MX2010 Extended Cable Manager | 389
Installing the MX2010 Extended DC Cable Manager | 389
Installing an MX2010 MIC | 390
Installing an MX2000 SFB | 394
Installing an MX2010 CB-RE | 401
Installing MX2000 Router AC Power Supply Modules | 403
Installing MX2000 Router DC Power Supply Modules (-48 V) | 406
Installing an MX2000 Router Three-Phase Delta AC Power Distribution Module | 410
Installing an MX2000 Router Three-Phase Wye AC Power Distribution Module | 416
Installing an MX2000 Single-Phase AC Power Distribution Module | 422
Installing an SFP or XFP into an MX2000 MPC or MIC | 427
Replacing Components | 429
Tools and Parts Required for Replacing MX2010 Hardware Components | 430
Tools and Parts Required to Remove Components from an MX2010 Router | 432
Removing a CB-RE from an MX2000 Router | 433
Upgrading to the Control Board-Routing Engine REMX2K-X8-64G in a Redundant Host
Subsystem | 435
Taking the Host Subsystem Offline | 436
Removing the Backup CB-RE | 437
Installing the REMX2K-X8-64G CB-RE | 438
Verifying and Configuring the Upgraded CB-RE as the Master | 439
Verifying and Configuring the Upgraded CB-RE as the Backup | 439
Upgrading to the REMX2K-X8-64G CB-RE in a Nonredundant Host Subsystem | 440
Taking the Host Subsystem Offline | 440
Removing the CB-RE | 441
xi