Juniper MX2010 Hardware Manual page 598

16. Screw the retaining nut onto the AC power cord to secure it to the metal wiring compartment.
17. Using a number 2 Phillips (+) screwdriver, tighten the four captive screws on the metal AC wiring
compartment.
18. Verify that the AC power cord does not touch or block access to router components, and that it does
not drape where people could trip on it.
19. Remove the ESD grounding strap from the ESD points on the chassis. Connect the strap to an approved
site ESD grounding point. See the instructions for your site.
20. Connect the AC power cord plug to the power source.
21. Switch on the customer-site circuit breakers to provide voltage on the AC power cord.
22. Remove the ESD grounding strap from the approved site ESD grounding point. See the instructions
for your site. Reconnect the strap to one of the ESD points on the chassis.
23. Verify that the LED on the PDM faceplate is lit steadily, indicating that the AC terminal block is receiving
power.
RELATED DOCUMENTATION
MX2000 Three-Phase Delta AC Power Distribution Module Description | 100
MX2000 Three-Phase Delta and Wye AC Power Distribution Module LEDs | 107
Connecting AC Power to an MX2000 Router with Three-Phase Delta AC Power Distribution
Modules | 291
Powering On a Three-Phase AC-Powered MX2000 Router | 319
Powering Off the AC-Powered MX2000 Router | 697
Troubleshooting the MX2000 Router Power System | 320
MX2000 AC Power Cord Specifications | 170
MX2000 AC Power System Electrical Specifications | 173
MX2000 Three-Phase Delta AC Power Distribution Module Electrical Specifications | 178
582