Juniper MX2010 Hardware Manual page 509

Figure 253: Removing a DC PDM (240 V China) from an MX2000 Router
8. The PDM is extended slightly away from the chassis. See
9. With both hands, grasp the two handles and gently pull the PDM straight out of the chassis.
CAUTION:
get damaged.
NOTE: Each PDM slot not occupied by a DC PDM must be covered by a PDM blank
panel.
10. Place the PDM onto an antistatic mat or into a ESD bag.
Do not touch the power connectors on the back of the PDM. It can
Figure 253 on page 493.
493