Juniper MX2010 Hardware Manual page 276

To install the router transport kit:
1. Remove the router transport kit from the shipping crate (see
Kit" on page 228).
NOTE: The router transport kit weighs approximately 138.5 lb (62.82 kg).
2. Remove the winch strap plate that is secured to the winch mount by using a 9/16-in. (14 mm) socket
wrench, and set the plate aside.
3. Using a number 3 Phillips screwdriver, loosen the captive screws that secure the winch mount to the
router transport kit, and set the mount aside.
4. Using a number 3 Phillips screwdriver, loosen the captive screws that secure the router transport
mounting plate and wheel assembly (left and right) to the router transport platform, and set them aside
(see Figure 100 on page
Figure 100: Preparing the Router Transport Kit for Installation
5. Remove the four shipping brackets that secure the router to the shipping crate platform using a
9/16-in. (14 mm) socket wrench, and a number 2 Phillips screwdriver, and set the brackets aside.
259).
"Unpacking the MX2010 Router Transport
259