Juniper MX2010 Hardware Manual page 407

d. On the bottom of the MPC, insert a screw into each of the four holes labeled S, and then tighten
them completely.
e. Install the MPC as described in
Figure 182: Installing the Septum
Slide septum
into MPC.
Install two
screws.
3. If the MIC uses fiber-optic cable, verify that a rubber safety cap is over each transceiver on the faceplate.
Install a cap if necessary.
4. On the MPC, pull the ejector lever that is adjacent to the MIC you are installing away from the MPC
faceplate.
5. Align the rear of the MIC with the guides located at the corners of the MIC slot.
6. Slide the MIC into the MPC until it is firmly seated in the MPC.
CAUTION:
components on the MIC.
7. Verify that the ejector lever is engaged by pushing it toward the MPC faceplate.
8. If the MIC uses fiber-optic cable, remove the rubber safety cap from each transceiver and the end of
each cable.
WARNING:
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable connected
to a transceiver emit laser light that can damage your eyes.
"Installing an MX2010 MPC into an Adapter Card" on page
Install four screws
on bottom.
Slide the MIC straight into the slot to avoid damaging the
Do not look directly into a fiber-optic transceiver or into the ends
391
533.