Configuring Terminal Attributes - H3C S9500 Series Operation Manual

Operation Manual – Getting Started
H3C S9500 Series Routing Switches
By default, the flow control on an asynchronous port is none, that is, no flow control will
be performed.
III. Configuring parity
Table 4-5 Configure parity
Configure parity mode
Restore the default parity mode
By default, the parity on an asynchronous port is none, that is, no parity bit.
IV. Configuring the stop bit
Table 4-6 Configure the stop bit
Configure the stop bit
Restore the default stop bit
By default, an asynchronous port supports 1 stop bit.
Note that setting 1.5 stop bits is not available on S9500 series at present.
V. Configuring the data bit
Table 4-7 Configure the data bit
Configure the data bit
Restore the default data bit
By default, an asynchronous port supports 8 data bits.

4.2.4 Configuring Terminal Attributes

The following commands can be used for configuring the terminal attributes, including
enabling/disabling terminal service, disconnection upon timeout, lockable user
interface, configuring terminal screen length and history command buffer size.
Perform the following configuration in user interface view. Perform lock command in
user view.
Operation
Operation
Operation
Chapter 4 User Interface Configuration
Command
parity { even | mark | none | odd | space }
undo parity
Command
stopbits { 1 | 1.5 | 2 }
undo stopbits
Command
databits { 7 | 8 }
undo databits
4-4