Installing A System Tray - Silicon Graphics Octane III Component Replacement Manual

Deskside

Hide thumbs Also See for Octane III:

Table of Contents

1: Component Replacement

Installing a System Tray

Use the following steps to install a system tray into the Octane III deskside enclosure after

replacing/upgrading DIMMs, disk drives, and/or PCIe cards in the tray:

Warning:

Ensure that the workstation is disconnected from site power (by disconnecting

the AC power cord[s] from the power outlet or rear of the system) before you attempt to

install a system tray. Failure to do so can expose you to dangerous power levels, resulting in

injury or death.

Access the system trays (refer to "Accessing the System Trays" on page 16).

2. Align the tray with the targeted tray slot in the enclosure.

3. Slide the tray all the way into the enclosure until it is seated firmly in the connectors at the

rear of the slot; refer to Figure 1-3 on page 19.

4. Install the three screws that secure the tray to the chassis.

5. Connect the required cables (Ethernet, InfiniBand, USB, etc.) to the tray.

6. Reinstall the rear fan assembly; refer to "Installing the Rear Fan Assembly" on page 46.

7. Plug the AC power cord[s] into the rear of the system and the power outlet.

8. Move the system enable switch on the rear of the enclosure to the ON position.

9. Boot the operating system.

007-5650-001

Table of Contents