2: Installation of Customer Replaceable Components
Retaining slots
Securing the System
48
Figure 2-26
Installing I/O Panel Gasket
The Silicon Graphics 330 Visual Workstation's side panel can be locked into place on the
system using a locking loop and a padlock, thus preventing access to the internal
components of the system. The locking loop is stored in a slot on the chassis and needs
to be moved to another slot to be used. Follow these steps to install the locking loop:
1.
Remove the side panel if not already done. For removal of the side panel, refer to
"Pre-installation Instructions" on page 16.
2. Locate the locking loop. See Figure 2-27 for the location of the locking loop.
Notched fingers
007-4278-001