2: Installation of Customer Replaceable Components
40
The following instructions describe how to install expansion cards:
1.
Remove the side panel as described in "Pre-installation Instructions" on page 16, if
not already done.
2. If a filler plate covers the slot opening selected for installation, follow these
instructions to remove it:
•
Remove the retaining screw shown in Figure 2-19.
•
Remove the filler plate from the chassis.
Filler plate
retaining screws
Figure 2-19
Location of the Retaining Screw for the Expansion Slot Filler Plate
3. Insert the expansion card into its slot by pushing the card into the connector until it
is properly seated. Figure 2-20 illustrates the procedure.
4. Tighten the retaining screw, as shown in Figure 2-20.
007-4278-001