HPE XP7 Automation Director User Manual page 306

NOTE: When volumes are disconnected, this service template waits the number of seconds that has
been specified for the openstack.checkVolumeDetachmentInterval property, and then repeats the action
to check the status of the volumes the number of times that is specified for the
openstack.checkVolumeDetachmentCount property. Adjust the value of each property, according to the
environment in use. When volumes are deleted, this service template waits the number of seconds that is
specified for the openstack.checkVolumeDeletionInterval property, and then repeats the action to check
the status of the volumes the number of times that is specified for the
openstack.checkVolumeDeletionCount property. Adjust the volume of each property, based on your
environment.
Service Definition Properties
The following table lists the properties shown in the Service Definition window for the Delete a Virtual
Server (virtual disk) service template.
Property Key
openstack.targetHost
openstack.identityServer
HostName
openstack.userName
openstack.password
openstack.protocol
openstack.portNumber
openstack.projectName
openstack.deleteVolume
Enabled
306 Additional service templates
Property Name
Host name of the
OpenStack control
server
Host name of the
Identity server
User name for logging
on to the Identity server
Password for logging on
to the Identity server
Identity server
connection protocol
Port number for
connecting to the
Identity server
Project name
Whether to delete
volumes
Description
Specify the host name or
IP address of the
OpenStack control
server. Make sure that
you do not specify an
IPv6 address.
Specify the host name or
IP address of the Identity
server. Make sure that
you do not specify an
IPv6 address.
Specify the user name
for logging on to the
Identity server.
Specify the password for
logging on to the Identity
server.
Specify the protocol that
is used to connect to the
Identity server.
Specify the port number
for logging on to the
Identity server.
Specify a project name.
After disconnecting the
volume, specify whether
to delete the volume. If
Yes is selected, the
volume is deleted.
Required or optional
R
R
R
R
R
R
R
R
Table Continued