HPE XP7 Automation Director User Manual page 299

a. Date and time when the backup was created (Header name: Backup time, format: yyyy/MM/dd
HH:mm:ss).
b. Project name (Header name: Project name).
c. Instance name (Header name: Instance name).
d. Volume ID (Header name: Volume ID).
e. Volume name (Header name: Volume name).
f. Backup ID (Header name: Backup ID).
2. During the creation of temporary volumes, a volume status check is performed for the number of times
specified by the property openstack.checkVolumeCreationCount, at intervals specified (in seconds) by
the property openstack.checkVolumeCreationInterval. Adjust the values of these properties based on
your environment.
3. During the backup of volumes, a volume status check is performed for the number of times specified
by the property openstack.checkVolumeBackupStateCount, at intervals specified (in seconds) by the
property openstack.checkVolumeBackupStateInterval. Adjust the values of these properties based on
your environment.
4. During the deletion of temporary volumes, a volume status check is performed for the number of times
specified by the property openstack.checkVolumeDeletionCount, at intervals specified (in seconds) by
the property openstack.checkVolumeDeletionInterval. Adjust the values of these properties based on
your environment.
Service Definition Properties
The following table lists the properties shown in the Service Definition window for the Back Up Volumes
service template.
Property Key
openstack.targetHost
openstack.identityServer
HostName
openstack.userName
openstack.password
openstack.protocol
Property Name
Host name of the
OpenStack control
server
Host name of the
Identity server
User name for logging
on to the Identity server
Password for logging on
to the Identity server
Identity server
connection protocol
Description
Specify the host name or
IP address of the
OpenStack control
server. Make sure that
you do not specify an
IPv6 address.
Specify the host name or
IP address of the Identity
server. Make sure that
you do not specify an
IPv6 address.
Specify the user name
for logging on to the
Identity server.
Specify the password for
logging on to the Identity
server.
Specify the protocol that
is used to connect to the
Identity server.
Additional service templates
Required or optional
R
R
R
R
R
Table Continued
299