HPE XP7 Automation Director User Manual page 235

Property Key
vmware.targetHost
vmware.vCenterServerN
ame
vmware.userName
vmware.password
vmware.portNumber
vmware.protocol
vmware.checkPowerStat
eCount
Property Name
Host name of VMware
vCenter control server
VMware vCenter server
name
User name for VMware
vCenter Server
connection
Password for VMware
vCenter Server
connection
Port number for VMware
vCenter Server
connection
Protocol for VMware
vCenter Server
connection
Power status check
count
Description
Specify the host name or
IP address of the server
(a server with vSphere
PowerCLI installed) that
will be used to control
VMware vCenter. You
cannot specify an IPv6
address.
Specify the host name or
IP address of the
VMware vCenter server.
You cannot specify an
IPv6 address.
Specify the user name to
use when connecting to
the VMware vCenter
server.
Specify the password to
use when connecting to
the VMware vCenter
server.
Specify the port number
to use when connecting
to the VMware vCenter
server (specifically, the
port number of the
VMware vCenter
server's Web service). If
you omit this property,
the default value of the
VMware vCenter server
applies.
Specify the protocol to
use when connecting to
the VMware vCenter
server.
Specify the number of
times the service
attempts to check the
power status to confirm
that the virtual server
has stopped and started.
The maximum wait time
is determined by this
property and the
property that defines the
power status check
interval.
Additional service templates
Required or optional
R
R
R
R
O
R
R
Table Continued
235