HPE XP7 Automation Director User Manual page 115

Data item
Definition ID
(Id)
Connection destination type
(Method)
Connection destination
(IP Address/Host Name)
Service resource group
(Service Group)
Authentication information
(Authentication)
Protocol
(Protocol)
Description
Specifies the ID of the agentless connection-destination definition
to update. If a null character is specified, the agentless connection-
destination definitions are registered as an addition. If the
agentless connection-destination definition of the specified ID does
not exist, the system generates an error.
Specifies any of the following connection destination types:
• IPv4: The connection destination is an IP address in IPv4
format.
• IPv6: The connection destination is an IP address in IPv6
format.
• HostName: The connection destination is a host name.
Specifies the IP address or host name of the connection-
destination host.
Specifies the service group to allocate to the agentless connection-
destination definition.
Note: This parameter is ignored from Automation Director v8.5.1
onward because agentless connection settings are allocated to
infrastructure groups.
Specifies whether to set authentication information:
• Enable: Authentication information is set.
• Disable: Authentication information is not set.
When the system displays the message "Authentication
information is not set," any additional data is ignored. However, the
data item is still required.
Specifies one of the following protocols:
• Windows: Connect using a Windows-based OS.
• SSH: Connect using SSH.
• Telnet: Connect using Telnet.
Table Continued
CLI commands 115