Motion Detection - EverFocus PowerPlex EDR-920 Installation & Operation Manual

3.5 MOTION DETECTION

MOTION SETUP MENU
CAMERA 1
CAMERA 2
CAMERA 3
CAMERA 4
CAMERA 5
CAMERA 6
CAMERA 7
CAMERA 8
CAMERA 9
SUMMARY
Menu display for EDR-920, EDR1640 identical, but with 16 cameras.
Define all motion detection settings for the individual cameras in the MOTION DETECTION menu.
Use the JOG to select the cameras from the list on the left.
(1) MOTION:
ENABLE: Motion detection is activated.
DISABLE: Motion detection is deactivated.
ATTENTION: Motion detection is automatically deactivated upon opening an on-screen display!
(2) SENSITIVITY:
Define the trigger sensitivity in 10 steps (1 – lowest, 10 – highest). Check the
setting by carrying out a moving test within the zone setting.
(3) DURATION: Alarm duration upon motion detection. Duration applies to recording, screen
change, buzzer and output contact and is adjustable from 1~99 seconds.
(4) ALARM OUTPUT:
Output relay activation.
1 ~ 4: Output relay 1~4 (selection) is switched in case of motion detection.
NONE: Output relay is deactivated.
COPY function
Motion detection settings can be copied from one camera to another. The zone
settings cannot be copied.
Select the camera to be copied from the camera list on the left and press the
COPY key.
The message "COPIED" appears at the top screen margin.
Select the camera which shall apply the settings from the camera list.
Press the SEARCH key to assign the copied settings to the camera.
The message "PASTED" appears at the top screen margin.
MOTION ENABLE
SENSITIVITY 07
DURATION 05 SEC
ALARM OUTPUT 01
E-MAIL NO
NETWORK NO
BUZZER DISABLE
MAIN MON NO CHANGE
CALL MON NO CHANGE
MATRIX 1 NO CHANGE
MATRIX 2 NO CHANGE
MATRIX 3 NO CHANGE
MATRIX 4 NO CHANGE
38