Configuring Pedestrian Detection Area - EverFocus H.265 VANGUARD II Series User Manual

4.1.8.4.1 Configuring Pedestrian Detection Area

Click the Setup button
Channel: Select a channel to configure the settings.
Snapshot Mode: Select a Snapshot Mode.
Realtime: System will take two snapshot images. One is when alarm triggered. The other

will be an optimal image that system recognized.
Default: System will take one snapshot images that is recognized as the optimal one.

Interval: Select this mode to further set up the Snapshot Quantity and Snapshot Interval.

- Snapshot Quantity: Select the number of snapshot image to take per set up interval.
- Snapshot Interval: Set up an interval to take the snapshot images.
Quick Mode: Set up the maximum recognition pixel size within a 1080p image.
Sensitivity: Select a Sensitivity value. The larger the value, the higher the sensitivity.
Detection Type: Select the detection type, Pedestrian, Vehicle or both.
Detection Mode: Select Static Mode or Motion Mode.
Detection Range: Select an area type.
Full Screen: Select Full Screen to detect the area of whole image.

Customize: Select Customize and resize the area by dragging the red dots at the edge.

1
Note: The configured areas should not be too narrow or small in order to enhance
the detection rate. The whole target object (people) should be inside the area.
to enter the Area setup page.
48
H.265 VANGUARD II Series