Acp 100 Configuration Example - Extron electronics DMP 128 FlexPlus User Manual

Create the following gain and mute groups from the
Configuring Groups
• Mute and Gain groups for all microphone channels.
• Mute and Gain groups for all program channels.
• Mute and Gain groups for each individual program source.
Mute group for all output attenuation blocks.
•

ACP 100 Configuration Example

1. From the DMP 128 FlexPlus main workspace in DSP Configurator, select
Tools > Configure ACP Panels
2. Select an empty tab from the top of the dialog box to build a new configuration (see
figure 164,
3. From the
dialog box populates with an ACP 100 graphic.
4. From the
bus ID set on the ACP 100 rear panel DIP switch assembly (see the ACP 100 Setup
Guide for information on setting the bus ID).
5. In the panel graphic on the left side of the
labeled
configuration.
6. From the
side of the
a. From the
microphone source channels. This group must be created from the
Groups
Groups
b. From the
microphone source channels.
Figure 164.
7. From the panel graphic on the left side of the dialog box, select the button labeled
(see figure 164,
on page 70).
. The
below).
1
drop-down, select
ACP Panel Type
drop-down menu (
ID # 3
is highlighted (yellow). When a button is highlighted, it is selected for
MIC
drop-down, choose
Control Type
dialog box, more configuration options appear.
Configure ACPs
drop-down (
Volume Master
dialog box before it can be selected from the drop-down (see
on page 70).
drop-down (
Mute Master
Starting ACP 100 Configuration
above).
7
Configure Groups
dialog box opens.
Configure ACPs
( ). The
2
ACP 100
), select the ID number that corresponds with the
dialog box, the button
Configure ACPs
Selector-Vol/Mute
), select the gain group containing all
5
), select the mute group containing all
6
DMP 128 FlexPlus • Audio Control Panels
dialog box (see
Configure ACPs
( ). On the right
4
Configure
Configuring
PRGM
103