Extron electronics DMP 128 FlexPlus User Manual page 150

Command
Dante Control and Configuration
The following commands configure the DMP 128 FlexPlus to listen for and pass through SIS commands meant for
Extron AXI 02 AT, AXI 22 AT, and AXI 44 AT endpoints.
NOTE: The DMP must be set to Verbose mode 2/3 when using the Dante Control and Configuration
commands.
Get available remote
devices
Enable remote
connection for listening
Read remote
connection listening
status
Get remote devices we
are listening to
Send command to
remote device
KEY:
X& = Dante Device Name
X2@ = Extron Remote Connection
Mode
ASCII command
(host to device)
E }
A EXPR
E X& X2@ }
C * EXPR
E X& }
C EXPR
E }
L EXPR
X& }
{dante@ :<SIS>}
Device names are not case sensitive
0 = Disabled
1 = Enabled
DMP 128 FlexPlus • Remote Control and Configuration
Response
(device to host)
•X&]X&] ]]
...
X2@]
•X&]X&] ]]
...
Additional description
Verbose 2/3:
•X&]
ExprA
X&] ]]
...
Verbose 2/3:
X& X2@]
ExprC *
(All listening disabled when
Dante module rebooted)
Verbose 2/3:
X& X2@]
ExprC *
Verbose 2/3:
•X&]
ExprL
X&] ]]
...
Verbose 2/3:
X& ]
{dante@ }<SIS>
141