Upload Configuration Into Patton Pots Interface; Login To Webpage; Patton Firmware/Software - Extron electronics DMP Plus Series Configuration Manual

DMP Plus Series C V / C V AT – Patton POTS

2.3 Upload configuration into Patton POTS interface

After the IP address has been setup on the Patton POTS interface, the attached
configuration file must be uploaded via the webpage interface.

2.3.1 Login to Webpage

2.3.2 Patton Firmware/Software

• This configuration guide was developed using firmware R6.11
• If the software/Firmware needs to be updated:
• Connect to the internal Webpage via the IP address of the unit set in
the previous step
http://192.168.1.253
o
o the factory defaults for logging in:
 login: administrator
 Password: (leave the password empty )
o if firmware is up to date skip to
• The Software/Firmware information is displayed on the main page
when you log in:
• First download the Software from patton.com:
https://www.patton.com/support/upgrades/index.asp?um=SmartNode%20411x
o
• Connect to the webpage on the Patton POTS interface
http://192.168.1.253
o
o the factory defaults for logging in:
 login: administrator
 Password: (leave the password empty )
• From the Patton webpage Select Import/Export, Upper Left corner
o
Revision Date:
10/16/2020
2.3.3 Upload configuration File
Page 9 of 28