Device Settings; Unit Info - Extron electronics DMP 128 FlexPlus User Manual

4
5
6

Device Settings

The
DMP 128 FlexPlus. Select
dialog box. Device settings are only available when connected live to a device.
Within the
•
•

Unit Info

The
number, and device MAC address. Click in the
the listed naming parameters. Click
Figure 152.
Restore Default Building Blocks Button — If default building blocks that come
installed with DSP Configurator are deleted, click the
NOTE: Only the default building blocks can be restored with this function. User
created building blocks are not restored if deleted.
TIP: To avoid accidentally deleting user created building block files, once they are
created, export them to a safe location on the disk. This creates a backup copy of
the building block file, should it be deleted by the user by mistake.
New Folder Button — Click the
can be dragged into. Upon creation, a default folder name is highlighted and a custom
name can be entered. Click a folder name twice to edit the folder name.
Building Blocks Panel — This panel contains folders and building blocks. Click and
drag building blocks to change their order or place them inside folders. Click a building
block name twice to edit the building block name. Click a folder name twice to edit the
name of the folder.
dialog box provides access to general settings of the
Device Settings
Tools > Device Settings
dialog box, the following tabs are available:
Device Settings
Unit Info
Serial Settings
tab displays the unit name, firmware version, device model, device part
Unit Info
Unit Info Tab
button to create a new folder that building blocks
to open the
• IP Settings
Date/Time
•
Unit Name
to save the changes.
Apply
DMP 128 FlexPlus • Configuration Tools
button to restore them.
Device Settings
• Passwords
Dante Device
•
field to rename the device within
92