Extron electronics DMP 128 FlexPlus User Manual page 89

7. From the
Next Command
for an SIS response from each action before executing the next action in the macro
or executes the next command immediately without waiting for an SIS response.
The default is
Execute immediately
Dataviewer and follow SIS response syntax (see
a. Use the the
Delay
seconds of delay.
0.000
8. Click at the top of the dialog box and enter a new name for the macro in
Change Name
the text field. Default macro names are
Select Macro
9. Up to 32 actions can be configured per macro. Follow steps 3 through 7 to configure
additional actions. Right click the left-most field in an action to cut, copy, or paste
actions in a macro.
10. Connect Live to the DMP 128 FlexPlus and click
to the DMP 128 FlexPlus. Once the macro has been pushed, it can be run via DSP
Configurator, a control system, or SIS commands.
NOTES:
•
A macro cannot be run until it is pushed to the device. Edits made to an existing
macro must also be pushed to the device.
• Macro configuration data is saved on a per-line basis. When an action is completely
configured, the data is saved even if the
• Macro configurations are saved when the DSP Configurator configuration file is
saved.
• If DSP Configurator is closed without saving the configuration file or pushing the
macro to a DMP 128 FlexPlus, unsaved macro configuration data is deleted.
To delete a Macro:
1. Click
Tools > Configure Macros
2. From the
Select Macro
3. Once the macro information is displayed, click
left corner of the
Configure Macros
To clone a Macro:
1. Click
Tools>Configure Macros
2.
From the
Select Macro
3. Click at the bottom of the
Clone Macro
4. Use the drop-down in the
macro. By default, the next empty macro slot is selected as the destination.
NOTE: If a macro already exists in the selected destination, a warning message
appears below the drop-down, warning that the existing macro will be overwritten
with the cloned macro.
5. Click to clone the macro or
OK
6. After the macro is cloned, the new macro is displayed in the
box. The cloned macro has a default macro name.
drop-down, select whether the DMP 128 FlexPlus waits
. Responses can be viewed through Extron
DSP SIS Commands
field to enter the amount of delay in seconds. The default is
Push Macro to Device
Configure Macros
.
drop-down, choose the macro to be deleted.
Delete Current Macro
dialog box.
.
drop-down, choose the macro to be cloned.
Configure Macros
dialog to select a destination for the cloned
Clone Macro
to cancel the action.
Cancel
DMP 128 FlexPlus • Configuration Tools
on page 142).
, , and so on.
Macro 1 Macro 2
to push it
dialog box is closed.
in the bottom
dialog box.
dialog
Configure Macros
80