Dante Device - Extron electronics DMP 128 FlexPlus User Manual

Dante Device

This tab allows the DMP 128 FlexPlus Dante settings to be configured within DSP
configurator without opening Dante Controller.
ATTENTION: It is essential that a Dante device be named immediately after it is
connected to the Dante network and before audio connections with other devices are
established. Existing connections are removed when a device is renamed.
Dante Device Name
A Dante device can be renamed to identify the device on the
audio network.
To assign the Dante device name:
1.
Select
2. Use the arrows to navigate to the
(see figure 157,
3. Click the
4. Enter a device name for the Dante interface.
5.
Click
Apply
6. Click
Yes
will be removed after the name is changed.
Dante Device Network Settings
To configure Dante network settings:
1. Select the
Dante interface will be assigned an IP address by the DHCP server and Dante network
configuration is complete. If
2. Enter a valid network configuration into the respective fields.
3. Click
Apply
To reboot the Dante interface:
1. Click
Reboot Dante
DMP 128 FlexPlus.
To refresh the device name and network configuration displayed:
1. Click
Refresh
FlexPlus Dante interface.
Redundant Mode
In redundant mode, the 2-port AT switch becomes separate Primary and Secondary ports
(see Redundant Configuration
To enable redundant mode:
1.
Click the
2. By default, the
redundant network configuration. If necessary, select the
the redundant network configuration in the text boxes that appear below.
NOTE: A valid redundant static network configuration must be entered.
Tools > Device Settings
).
1
text box (
Device name 2
( ). A confirmation dialog box opens.
3
, to confirm existing connections
or radio buttons (
DHCP Static IP
Static IP
.
( ). Only the Dante interface will reboot, not the entire
5
( ) to have DSP Configurator refresh information from the DMP 128
6
on page 116).
Enable Redundant Mode
radio button is selected to have the DHCP server assign a
DHCP
.
tab
Dante Device
).
Figure 157. Dante Device Tab in
Device Settings Dialog
Box
). If using DHCP, the DMP 128 FlexPlus
4
is selected, proceed to step 2.
checkbox.
Static
DMP 128 FlexPlus • Configuration Tools
radio button and enter
95