Aux Input Building Blocks; Aux Input Processing; Aux Input Gain Block - Extron electronics DMP 128 FlexPlus User Manual

Aux Input Building Blocks

Building blocks can be applied to all eight Aux input channels. These buildings blocks
function the same as the mic/line input building blocks (see
page 21 for more information on configuring Aux input building blocks).

Aux Input Processing

The input processing chain in DSP Configurator is visually represented by a string of blocks.
Each block contains a specific processor or type of processor. Aux Inputs 1 through 8
contain the following signal processing chain:
1.
2.
3.
4.
5.
6.

Aux Input Gain Block

By default, the Aux input gain block does not have an input source selected. Double-click
the block to open the input selection drop-down, presenting three options for each Aux
input source:
•
•
•
Player Input
Double-click the Aux input gain block and hover the mouse over
the eight available players. If no audio file is assigned to the player, the player displays
[unassigned]
(see
players to insert it as the source for the selected Aux input.
Figure 71.
Once a player is selected as an Aux input source, start and stop controls are available in
Live mode by right clicking the input gain dialog and hovering over
Figure 72.
Aux Input Gain Block
Aux Input Filter Block
Aux Input Dynamics Block
Aux Input Ducking Block
Aux Input Automix Block
Aux Input Pre-Mixer Gain Block
Player — Plays audio files stored on the DMP 128 FlexPlus internal memory.
USB — Receives audio input from the rear panel USB port.
VoIP (V-model only) — Receives audio input from the VoIP network.
. If an audio file is assigned to the player, the player displays the filename
Players on page 75 for more information on configuring players). Select one of the
Aux Input Player Selection
Player Start and Stop Controls
Input Building Blocks
(2)
DMP 128 FlexPlus • DSP Configurator Software
on
to display
Player...
.
Player Control...
42