Extron electronics DMP 128 FlexPlus User Manual page 156

Command
Aux Input 1 through 8
Set source mode
Get source mode
Set mute
Get mute status
Set analog gain
Read gain
Aux Output 1 through 8
Set output mode
Get output mode
Set mute
Get mute status
Set attenuation
Read attenuation level
Metering
NOTE: Metering is available on all input gain and output attenuation blocks.
Read meter level
Enable meter updates
Automixer Gate Monitoring
Get current automixer
gate status
Unsolicited automixer
gate status update
Signal Level Monitoring (SLM)
SLM tracks when the signal at a metered gain OID crosses a set threshold level. When SLM is enabled for an OID,
an unsolicited message is sent when the threshold level is crossed. The response includes the OID, meter on/
off status, level after the threshold was crossed, and if the level was going up or down when the threshold was
crossed.
Set SLM status
Get current threshold
status
Unsolicited meter value
KEY:
• Variables not defined on this page are defined on the following page.
X7@ = Target OID
= Gain value
X7#
= Mute status
X7$
ASCII command
(host to device)
E X7@ X8& }
D * AU
E X7@ }
D AU
E X7@ X7$ }
M * AU
E X7@ }
M AU
E X7@ X7# }
G * AU
E X7@ }
G AU
E X7@ X9) }
D * AU
E X7@ }
D AU
E X7@ X7$ }
M * AU
E X7@ }
M AU
E X7@ X7# }
G * AU
E X7@ }
G AU
E X7@ }
V AU
E X7@ X8* }
V * AU
E X7@ }
J AU
This is enabled by selecting
the dialog
Automix
checkbox
Monitor Gate
(see Input Automix Block
on page 38).
E X7@ X9$ }
J * AU
E X7@ }
J AU
Object ID (OID) Number Tables
See
dB value in 0.1 dB steps. Gain uses 10x multiplier (+10 dB = 100,
-3.4 dB = -34, and so on).
0 = off, 1 = engaged
DMP 128 FlexPlus • Remote Control and Configuration
Response
(device to host)
X7@ X8&]
DsD *
X8&]
X7@ X7$]
DsM *
X7$]
X7@ X7#]
DsG *
X7#]
X7@ X9)]
DsD *
X9)]
X7@ X7$]
DsM *
X7$]
X7@ X7#]
DsG *
X7#]
X8* X8(]
*
X7@ X8*]
DsV *
X9!]
X7@ X9@ X9% X9^]
DsV * * *
X7@ X9$]
DsJ *
X9$]
X7@ X9@ X9% X9^]
DsV * * *
Additional description
-150.0 dBFS to 0.0 dBFS
on page 151
147