Overall Configuration Procedure For The Control Processor - Extron electronics IPCP Pro PCS1 Setup Manual

IPCP Pro PCS1 • Setup Guide (Continued)

Overall Configuration Procedure for the Control Processor

Within Global Configurator
(GC Professional or
GC Plus mode):
Overall Configuration Steps
Figure 4.
For information on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related topics,
see the Extron Safety and Regulatory Compliance Guide
© 2018 Extron Electronics All rights reserved. All trademarks mentioned are the property of their respective owners.
10
Configure the IP settings of
the control processor and the
TouchLink Pro touchpanels.
If desired or required, install a new
security certi cate (via Toolbelt).
Create a new GC Professional or GC Plus project
and add the control processor to it.
Will
TouchLink Pro or
third party touchpanels or
No
other user interfaces
be used?
Con gure ports on the
control processor.
Create monitors, schedules, timers,
macros, and local variables.
Add touchpanels or other interfaces
(if used) to the project.
Import GUI layouts and con gure the
touchpanels or other interfaces.
Save the project.
Build and upload the con guration to
the control processor.
Test the system, make adjustments,
nalize con guration.
See Network Network
Communication Setup Communication Setup
on page 3.
Yes
Create GUI layouts for the
touchpanels or other interfaces:
1. Start GUI Designer.
2. Create GUI layout designs for each
TouchLink Pro, third party
touchpanel (with a TouchLink
Interface), or a computer or
mobile device (with LinkLicense).
3. Save and build the GUI layout le.
Or...
Download existing GUI layouts
from identical touchpanels.
on the Extron website.
68-2438-53
Rev. A
www.extron.com
10 18