Options; Expansion Bus; Connecting The Exp Ports - Extron electronics DMP 128 FlexPlus User Manual

Options

The
DSP Configurator color schemes, default processor and gain block behavior, as well as a
number of other settings. For a comprehensive overview of the
DSP Configurator Help file.
Figure 158.

Expansion Bus

With the Extron Expansion (EXP) port, two EXP-enabled devices can be connected for
bidirectional streaming of up to 16 channels of audio. EXP inputs and outputs contain DSP
(see

Connecting the EXP Ports

When connecting a DMP 128 FlexPlus to another EXP-enabled device for EXP
communication, the DMP 128 FlexPlus is always set as the primary unit. The primary unit
serves as the master clock for all EXP audio communication. The other unit must be set as
a secondary unit in order for a connection to be established.
The following procedure describes how to set up a DMP 128 FlexPlus model with another
EXP-enabled non-AT device for EXP communication (see
FlexPlus Device and an EXP-enabled non-AT Device
NOTE: Two DMP 128 FlexPlus devices cannot be connected via the EXP port because
dialog box allows the user to edit and reset default options for
Options
Options Dialog Box
Expansion and AT Inputs
AT models can only be configured as a primary unit and cannot be set as a secondary
unit. Instead, use the rear panel AT switch to connect the two devices over a Dante
network (see Dante Controller
on page 51 and Expansion Outputs
Connecting a DMP 128
on the next page).
on page 109).
DMP 128 FlexPlus • Configuration Tools
dialog box, see the
Options
on page 63).
96