Configuring A Macro - Extron electronics DMP 128 FlexPlus User Manual

Configuring a Macro

1.
Click
Tools > Configure Macros
2. Select an empty macro slot from the
3. From the
Choose
destination. If choosing
NOTE: Macro commands can only be sent to remote destinations via the
LAN/VoIP 1 port (V-model only).
a. After selecting
box opens.
b. Complete the form in the dialog box, including username and password, if required.
c. Select
d. Click
e. Select the newly created remote destination from the
4.
From the
• Recall Preset — Recall an existing preset.
• Set Group Gain — Set the level of an existing gain group.
Group Gain Inc/Dec — Set the increment/decrement values of an existing gain
•
group.
• Set Group Mute — Mute or unmute an existing mute group.
• Gain — Set the gain of a specific gain block on a specific channel.
• Mute — Mute or unmute a specific gain block on a specific channel.
Set Phantom Power – Enable or disable phantom power on a specific
•
Mic/Line input channel.
• Meters On/Off — Enable or disable level meters at the input gain or output
attenuation stages of a specific channel.
• Start Player — Starts a selected player.
Stop Player — Stops a selected player.
•
• SIS Command — Type in a single SIS command to perform an action not listed
above (see
NOTE: Use the
Set Input Format — Specify whether mic/line inputs receive analog signal from the
•
inputs or digital signal via the Dante network (see
• Dial Number — Use a specific VoIP line to dial a string.
Dial Digits — Use a specific VoIP line and line appearance to dial a predetermined
•
number, such as an extension number or conference pin.
End Call — End calls on a specific line or all appearances of a VoIP line.
•
5. Once the action is chosen, up to four additional selections are made available. These
additional selections must be completed in order to proceed to the next macro step.
For example, if
selection of a gain group to be affected and
the selected group.
6. When all of the action selections are configured, a new line appears at the bottom of the
form so another action can be configured.
. The
drop-down, select a destination for the macro action.
Destination
for the local DMP 128 FlexPlus, or
Local
, proceed to step 4.
Local
Add Destination...
to add the device to the drop-down in the
Apply
to close the
Close Edit Remote Destinations
drop-down, select an action to be configured.
Action
Remote Communication and Control
key in place of
W
is the selected action,
Set Group Gain
dialog box opens.
Configure Macros
drop-down.
Select Macro
Add Destination...
, the
Edit Remote Destinations
Destinations
dialog box.
Destination
on page 123).
E
and the (pipe) key in place of
|
in figure 40
9
Selection 1
determines the gain level of
Selection 2
DMP 128 FlexPlus • Configuration Tools
for a remote
dialog
column.
drop-down.
}
.
on page 23).
prompts the
79