Remote Communication And Control; Connection Options - Extron electronics DMP 128 FlexPlus User Manual

Remote
Communication and
Control
This section describes how to control the DMP 128 FlexPlus with SIS programming and
covers the following topics:
•
•
•
•
•
•
•

Connection Options

The DMP 128 FlexPlus Digital Matrix Processor can be remotely connected via a host
computer or other device (such as a control system) attached to the rear panel RS-232 port
or LAN port, or the front panel USB Config port.
The DMP 128 FlexPlus can be set up and controlled using SIS commands or DSP
Configurator software (see
the configuration and control port connections. For information on DSP Configurator, see
DSP Configurator Software
SIS commands can be executed using the Extron DataViewer application available from
www.extron.com. The host computer issuing the commands can be connected via the
following connections:
•
•
•
Connection Options
Host-to-Device Communications
Using the Command and Response Tables
Command and Response Table for Basic SIS Commands
Command and Response Table for DSP SIS Commands
Command and Response Table for VoIP SIS Commands
Object ID (OID) Number Tables
Installation
on page 10).
RS-232 Port on the next page
LAN Port on the next page
USB Config Port on page 125
on page 4 for pin assignments and details on
DMP 128 • Remote Control and Configuration 123