Extron electronics DMP 128 FlexPlus User Manual page 123

Renaming a Receiver
The default names shown in the
interface of the connected device (see figure 176,
labelled through
EXP_In-01
at the 48 EXP inputs. Follow the instructions on the next page to rename a receiver.
To rename a DMP 128 FlexPlus receiver:
1. From the menu on the
Device
< > on the keyboard. The
Ctrl+D
2. From the
(Select a Dante Device..)
desired DMP 128 FlexPlus (see figure 177,
3. On the screen, select the
Device View
4. Click on the name of the receiver to be renamed. The name becomes a text box with a
cursor ( ).
3
5. Enter the new name (up to 31 characters) using any combination of letters, numbers,
and special characters except for
6. Press on the keyboard to confirm the name, or click another channel text box.
<Enter>
7. Repeat steps 4 through 6 to rename additional receiver channels.
8. When finished renaming receivers, close the
Figure 177. Device View Screen — Renaming a Receiver
Renaming a Transmitter
The default names shown in the
interface of the connected device (see
of DMP 128 FlexPlus transmitters is labelled
DMP 128 FlexPlus can transmit signal routed to the analog outputs to the Dante network.
The second set of DMP 128 FlexPlus transmitters is labelled
because the DMP 128 FlexPlus can transmit signal routed to the EXP outputs
Exp_Out-16
to the Dante network. Follow the instructions on the next page to rename a transmitter.
To rename a DMP 128 FlexPlus transmitter:
1. Select from the
Device View
< > on the keyboard. The
Ctrl+D
2. From the
(Select a Dante Device...)
DMP 128 FlexPlus (see figure 178,
3. On the screen, select the
Device View
4.
Click in the
Channel Label
renamed. A text box and cursor appear (
5. Enter a new name (up to 31 characters) using any combination of letters, numbers, and
special characters except for
column are extracted from the Dante
Dante Receivers
). The DMP 128 FlexPlus receivers are
1
because the DMP 128 FlexPlus can receive signal
EXP_In-48
screen, select
Network View
dialog box opens.
Device View
drop-down menu, select the name of the
below).
1
tab (
Receive
, , and (period).
@ = .
Device View
column are extracted from the Dante
Dante Transmitters
figure 176, on the previous page). The first set
2
Output-01
menu on the
Device Network View
dialog box opens.
Device View
drop-down menu, select the name of the
on the next page).
1
tab (
Transmit
column to the right of the name of the transmitter being
).
3
, , and (period).
@ = .
DMP 128 FlexPlus • Dante Controller
, or press
Device View
).
2
dialog box.
through because the
Output-08
through
EXP-Out-01
screen or press
).
2
114