Installation And Configuration; Installation Steps; Edge Blending - Extron electronics Quantum Ultra User Manual

Installation and
Configuration
This section provides the steps to install the Quantum Ultra processor. It also describes
the rear panel components and provides instructions for cabling. The following topics are
included:
•
•
•
•
•
•

Installation Steps

The Quantum Ultra processor can be mounted in a 19-inch equipment rack or placed
on furniture. To install and set up the Quantum Ultra processor for a videowall, follow the
steps below (see
1.
2.
3.
4.
5.
6.
Installation Steps
Rear Panel Features
Input and Output Cards
Adjusting for Mullion Compensation and Edge Blending
Connecting to a Network
RS-232 Insertion — DTP Outputs Only
Application Diagrams
Disconnect power from the Quantum Ultra and all other equipment in the system.
If desired, mount the processor to a rack (see
Connect HDMI sources and LAN connections to the installed input cards.
Connect HDMI displays, DTP or HDBaseT receivers, or an XTP matrix switcher to the
connectors on the installed output cards as appropriate.
Secure each HDMI connector with a provided LockIt bracket (see
Cable Lacing Brackets on page 13).
NOTE: With adapters, DVI is available on the HDMI ports.
Connect a control device or computer for remote control to:
a. The rear panel RJ-45 LAN A or LAN B jack to enable configuration and control of
the Quantum via Simple Instruction Set (SIS) commands (see
on page 49) or VCS (LAN A recommended) (see the VCS Help File), or for
streaming a VNC source (LAN B recommended).
b. (Optional) The front panel USB mini-B Config connector to enable control via VCS
or SIS commands.
c. (Optional) The rear panel 3-pole captive screw RS-232 connector to enable serial
control via SIS commands.
Connect AC power to the IEC connectors of the Quantum Ultra primary and
redundant (optional) supplies.
NOTE: Temperature controlled fans run at 100% as a failsafe if only one power
supply is operational.
Quantum Ultra Videowall Processing System • Installation and Configuration
on page 7 for connection examples).
Mounting
on page 90).
HDMI LockIt
SIS Commands
9