Installation; Dmp 128 Flexplus Models; Mounting - Extron electronics DMP 128 FlexPlus User Manual

Installation

This section describes the installation of the DMP 128 FlexPlus and covers the following
topics:
•
•
•
•
•

DMP 128 FlexPlus Models

Model
DMP 128 FlexPlus C AT
DMP 128 FlexPlus C V AT Dante Digital Matrix Processor with 12 AEC and VoIP

Mounting

The 1U high, half rack width, 9.5 inch deep DMP 128 FlexPlus mounts in the following
manners:
•
•
•
NOTE: To mount the DMP 128 FlexPlus using an Extron mounting kit, see the
DMP 128 FlexPlus Models
Mounting
Rear Panel Features and Cabling
Front Panel Features
Hardware Reset Modes
Description
Dante Digital Matrix Processor with 12 AEC
Rack mounting — Attach the DMP 128 FlexPlus to a standard 19-inch rack shelf.
The following Underwriters Laboratories (UL) guidelines pertain to the installation of the
DMP 128 FlexPlus in a rack:
• Reduced air flow — Install the equipment in the rack so that the amount of air
flow required for safe operation of the equipment is not compromised.
Mechanical loading — Mount the equipment in the racks so that uneven
•
mechanical loading does not create a hazardous condition.
• Circuit overloading — When connecting the equipment to the supply circuit,
consider the effect that circuit overloading might have on overcurrent protection
and supply wiring. Consider equipment nameplate ratings when addressing this
concern.
• Reliable earthing (grounding) — Maintain reliable grounding of rack-mounted
equipment. Pay particular attention to power supply connections other than direct
connections to the branch circuit (such as the use of power strips).
Under-furniture mounting — Mount the DMP 128 FlexPlus under the surface of a
desk, table, or podium.
Free-standing — Attach the four rubber feet provided with the device to the bottom of
the DMP 128 FlexPlus in the four corners and place the unit on furniture as desired.
instructions provided with the kit.
DMP 128 FlexPlus • Installation 4