Usb Config Port; Verbose Modes - Extron electronics DMP 128 FlexPlus User Manual

Establishing a Network Connection via LAN
1. Open a TCP socket to port 23 using the DMP 128 FlexPlus IP address.
NOTE: If the local system administrators have not changed the value, the factory
specified default, 192.168.254.254, is the correct value for this field.
2. The DMP 128 FlexPlus responds with a copyright message including the date, the
name of the product, firmware version, part number, and the current date/time.
3. If the device is password protected, enter the appropriate administrator or user
password.
a. If the password is accepted, the device responds with
Administrator
b.
If the password is not accepted, the
NOTES:
• The Ethernet link times out after a designated period of time of no communications.
By default, the timeout value is set to 5 minutes and can be changed (see
global IP port timeout
• Extron recommends leaving the default timeout at 5 minutes and periodically
issuing the
periods, disconnect the socket and reopen the connection when another command
must be sent.

USB Config Port

The DMP 128 FlexPlus has a front panel USB port that can be connected to a computer
as a host device running either the HyperTerminal or DataViewer utilities for control of the
device. Once a connection is established, SIS programming can begin (see
Device Communications

Verbose Modes

Telnet connections are used to monitor changes that occur, such as commands from other
Telnet sockets or a serial port. For a Telnet session to receive change notices, the Telnet
session must be in verbose mode 1 or 3
mode 1 or 3, the Telnet socket reports changes in messages that resemble SIS command
responses.
Tagged and Untagged Responses
When a query command is sent in verbose mode 0 or 1, only the "untagged" value is
returned. When a query command is sent in other verbose modes, the response is "tagged"
and resembles the response to a set command.
Examle: The gain query command
appear depending on the verbose mode:
• Untagged (verbose 0 or 1):
Tagged (verbose 2 or 3):
•
and the gain value.
NOTE: All query responses listed in this guide are untagged.
.
Password
on page 129).
( command to keep the connection active. If there are long idle
Query Q)
on the next page).
(Set verbose mode
E
G40000AU
]
, just the gain value with no other information.
626
DsG40000*626
DMP 128 FlexPlus • Remote Control and Configuration
Login User or Login
prompt reappears.
on page 132). In verbose
}
is sent. The following responses
]
, the type of query sent, the OID queried,
Set
Host-to-
125