Saving And Pushing Acp Configurations - Extron electronics DMP 128 FlexPlus User Manual

15. From the panel graphic on the left side of the dialog box, select the button labeled
PROGRAM
16.
From the
a. From the
program source channels.
b. From the
program source channels.
Figure 170.
The ACP 106 panel is now fully configured. From this point, either:
Add additional ACP panel configurations.
•
• Save the ACP panel configuration to the DSP Configurator configuration file (see Saving
and Pushing ACP Configurations below).
• Push the configurations to the DMP 128 FlexPlus (see Saving and Pushing ACP
Configurations below).

Saving and Pushing ACP Configurations

1. Configure up to eight ACP panels.
2. Close the
box is closed.
3. Save the configuration file. ACP configurations are saved with the configuration file.
4.
Connect Live to a DMP 128 FlexPlus via a LAN (TCP/IP) connection.
NOTE: The host computer must be connected to the DMP 128 FlexPlus LAN port
in order to push ACP configurations to the device.
5. Select
6. Click
Push Configuration to Device
Configure ACPs
(see figure 170, below).
©
drop-down (
Control Type
drop-down (
Volume Master
drop-down (
Mute Master
Configuring Mic and Program Selector Buttons
dialog box. Button configurations remain after the dialog
Configure ACPs
Tools > Configure ACP Panels
dialog box are pushed to the DMP 128 FlexPlus.
), choose
ª Selector-Vol/Mute
), select the gain group containing all
«
), select the gain group containing all
¬
. The dialog box opens.
Configure ACPs
. Configurations from all eight tabs in the
DMP 128 FlexPlus • Audio Control Panels
.
108