Extron electronics DMP 128 FlexPlus User Manual page 126

To configure the DMP 128 FlexPlus in redundant mode using Dante Controller:
1. Open Dante Controller.
2.
Press < > on the keyboard to access the
Ctrl+D
3. Select the desired DMP 128 FlexPlus from the
drop-down menu (see figure 182,
4. Select the
Network Config
5. From the
Dante Redundancy
Figure 182. Redundant Mode Configuration in Dante Controller
To configure the DMP 128 FlexPlus in redundant mode using DSP Configurator:
1. Use DSP Configurator to connect to the DMP 128 FlexPlus in Live mode (see
Emulate Panel on page 17).
2. Select
Tools > Device Settings
3. In the
Device Settings
and select the
Dante Device
4. Select
Enable Redundant Mode
5. Select or
DHCP Static IP
6. Click ( ).
Apply 4
Figure 183. Redundant Mode Configuration in DSP Configurator
Device View
(Choose a Dante Device...)
below).
1
tab ( ).
2
panel, use the drop-down to select
.
dialog box, use the right navigation arrow (
tab (see figure 183,
1
( ).
2
and enter a valid redundancy network configuration (
DMP 128 FlexPlus • Dante Controller
dialog box.
(
3
Redundant
Live and
) to navigate to
below).
3
).
).
117