Extron electronics DMP 128 FlexPlus User Manual page 86

s
To assign an audio file to a player:
1. Select the audio file from the
2.
Click and drag the audio file to the desired player (
being assigned to Player 1 in figure 134 below).
3. When the file has been assigned to a player, the player
name of the audio file assigned.
Figure 134. Assigning Audio File to Players
To start, stop, or clear a player:
1. Click a player with an audio file assigned to it (see figure 135,
2. Check the checkbox (
Repeat
(optional).
3.
Enter the amount of time in seconds the player should wait before repeating the file in
the field (
Repeat Delay
4. Click (
Start Player 4
NOTE: The player must be assigned to an Aux input before
are available (see
Stop Player
5. To stop the player, highlight the player with a single click, then click
6. To clear the player of its audio file, highlight the player with a single click, then click
( ).
Clear Player 6
Figure 135. Starting, Stopping, and Clearing Players
Files in the device
pink_noise_m20dB_10sec.raw
) to repeat the audio file after it has been played
2
) (optional).
3
).
Aux Input Gain Block
DMP 128 FlexPlus • Configuration Tools
panel.
field displays the
Filename
below).
1
and
Start Player
on page 42).
Stop Player
is
( ).
5
77