Extron electronics DMP 128 FlexPlus User Manual page 28

b. Push — Pushes the configuration file, presets, macros, and ACP configurations
open in DSP Configurator to the connected DMP 128 FlexPlus. This will overwrite
any configuration currently on the device.
Click
Advanced...
figure 26).
NOTE: If only pushing selected presets, the preset selection dialog box opens
after clicking
OK
Figure 26. Advanced Push Options Dialog Box
If only pushing selected presets, mark them from the dialog box shown in figure 27
below.
Figure 27. Preset Selection Dialog Box
4.
Once a push or pull is completed, the current state of the connected DMP 128 FlexPlus
is displayed in the DSP Configurator status panel and the device is ready for further
configuration.
Exit Live Mode and Enter Emulate Mode
1. Click the button in the DSP Configurator menu bar (see figure 28,
Emulate
Alternatively, select
Tools > Disconnect from Device
keyboard.
Figure 28. Emulate Button
to open the
Advanced Push Options
on the
Advanced Push Options
DMP 128 FlexPlus • DSP Configurator Software
dialog box (see
dialog box.
).
1
or press <F6> on the
19