Table of Contents
Advertisement
122
To activate/deactivate the tilt sensor:
1.
Press the P and S buttons.
2.
Enter the password required for service mode: 25483.
3.
Confirm with OK.
The service menu opens.
▲/▼
4.
Use
to select the parameter Machine configuration
(Machine config.).
5.
Confirm with OK.
Use ▲/▼ to select the Other Devices parameter.
6.
7.
Confirm with OK.
Use ▲/▼ to select Tilt Sensor.
8.
9.
Confirm with OK.
Important
The tilt sensor may only be deactivated in exceptional cases, only
for a brief time and only by qualified specialists.
▲/▼
10. Use
to change the setting to On/Off.
11. Confirm with OK.
The tilt sensor is activated/deactivated.
12. To exit service mode, press the ESC button.
5.10 Displaying the software version
To display the software version:
1.
Switch on the machine.
The start screen appears on the display:
• On the left, the firmware of the OP3000 control panel
• On the right, the control software version
The machine performs a reference run:
The display shows the seam program last used, or the
manual mode.
Operating Instructions 550-12-33/34 - 00.0 - 08/2017
Programming
Advertisement
Table of Contents
