Mitsubishi Electric Q Series Programming Manual page 7

Always install the servomotor with reduction gears in the designated direction. Failing to do so
may lead to oil leaks.
Store and use the unit in the following environmental conditions.
Environment
Ambient
temperature
Ambient humidity
Storage
temperature
Atmosphere
Altitude
Vibration
When coupling with the synchronous encoder or servomotor shaft end, do not apply impact such
as by hitting with a hammer. Doing so may lead to detector damage.
Do not apply a load larger than the tolerable load onto the synchronous encoder and servomotor
shaft. Doing so may lead to shaft breakage.
When not using the module for a long time, disconnect the power line from the Motion controller
or servo amplifier.
Place the Motion controller and servo amplifier in static electricity preventing vinyl bags and store.
When storing for a long time, please contact with our sales representative.
Also, execute a trial operation.
When you disinfect or protect wooden packing from insects, take measures except by fumigation.
Fumigating the Motion controller and servo amplifier or packing the Motion controller and servo
amplifier with fumigated wooden packing can cause a malfunction of the Motion controller and
servo amplifier due to halogen materials (such as fluorine, chlorine, bromine, and iodine) which
are contained in fumigant.
The Motion controller and servo amplifier must not be used with parts which contain halogen-
series flame retardant materials (such as bromine) under coexisting conditions.
CAUTION
Motion controller/Servo amplifier
According to each instruction manual.
According to each instruction manual.
According to each instruction manual.
Indoors (where not subject to direct sunlight).
No corrosive gases, flammable gases, oil mist or dust must exist
1000m (3280.84ft.) or less above sea level
According to each instruction manual
Conditions
0°C to +40°C (With no freezing)
(With no dew condensation)
A - 6
Servomotor
(32°F to +104°F)
80% RH or less
-20°C to +65°C
(-4°F to +149°F)