Parameter List - Mitsubishi Electric Q Series Programming Manual

Motion controller sv22 virtual mode
Hide thumbs Also See for Q Series:
Table of Contents

Advertisement

8 OUTPUT MODULE

8.4.3 Parameter list

No.
Setting item
1
Output axis No.
Number of pulses per cam shaft revolution
2
(N
) (2 words)
C
3
Cam No. setting device (1 word)
4
Permissible droop pulse value
5
Output unit
6
Stroke amount setting device (2 words)
7
Torque limit value setting device (1 word)
8
Comment
Lower stroke limit value storage device
9
(2 words)
Current value within 1 virtual axis revolution
10
storage device
(Main shaft side, 2 words)
Current value within 1 virtual axis revolution
11
storage device
(Auxiliary input axis side, 2 words)
12 Cam/ball screw switching command device
The cam parameters are shown in Table 8.5 and the parameters No.2 to No.12 shown
in this table are explained in items (1) to (11) below.
Refer to the help of MT Developer2 for the cam parameter setting method.
Table 8.5 Cam Parameter List
(1) Number of pulses per cam shaft revolution (Nc) (2 word)
(a) The number of pulses required to rotate the cam one cycle is set.
(b) The setting for the number of pulses per cam shaft revolution is not related
to the travel value per pulse (fixed parameter setting).
Default value
Q173DSCPU/Q173DCPU(-S1) : 1 to 32
0
Q172DSCPU
Q172DCPU(-S1)
0
6553500
mm
mm
-(300[%]) / word device (D, W, #, U \G)
None
(Note-1): The devices set in other parameter cannot be used.
Number of pulses per cam
shaft revolution (Nc)
8 - 29
Setting range
1 to 1073741824 [PLS]/
Word device (D, W, #, U \G)
Word device (D, W, #, U \G)
1 to 1073741824 [PLS]
inch
degree
Word device (D, W, #, U \G)
32 characters
- / word device (D, W, #, U \G)
- / word device (D, W, #, U \G)
- / word device (D, W, #, U \G)
(Note-1)
- / bit device
: 1 to 16
: 1 to 8
QDS
PLS
QDS

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents