Pulse Output With Arbitrary Pulse Width And Delay From Trgv Input; Figure 11.10 Example Of Pulse Output Synchronized To Trgv Input - Renesas H8 Series Hardware Manual

Section 11 Timer V
11.5.2

Pulse Output with Arbitrary Pulse Width and Delay from TRGV Input

The trigger function can be used to output a pulse with an arbitrary pulse width at an arbitrary
delay from the TRGV input, as shown in figure 11.10. To set up this output:
1. Set bits CCLR1 and CCLR0 in TCRV0 so that TCNTV will be cleared by compare match with
TCORB.
2. Set bits OS3 to OS0 in TCSRV so that the output will go to 1 at compare match with TCORA
and to 0 at compare match with TCORB.
3. Set bits TVEG1 and TVEG0 in TCRV1 and set TRGE to select the falling edge of the TRGV
input.
4. Set bits CKS2 to CKS0 in TCRV0 and bit ICKS0 in TCRV1 to select the desired clock source.
5. After these settings, a pulse waveform will be output without further software intervention,
with a delay determined by TCORA from the TRGV input, and a pulse width determined by
(TCORB – TCORA).
TCNTV value
H'FF
TCORB
TCORA
H'00
TRGV
TMOV

Figure 11.10 Example of Pulse Output Synchronized to TRGV Input

Rev. 1.00 Aug. 28, 2006 Page 160 of 400
REJ09B0268-0100
Compare match A
Compare match B
clears TCNTV and
halts count-up
Counter cleared
Compare match A
Compare match B
clears TCNTV and
halts count-up
Time