Connect The Sensor To The Monitoring System; Attach The Sensor To The Patient - Covidien Nellcor PM100N Home Use Manual

Connect the Sensor to the Monitoring System

1. Insert the extension cable connector firmly into the
SpO connector on the monitoring system. The
2
connector fits in one direction only.
2. Open the clear plastic latch on the extension cable,
and insert the sensor connector firmly. The
connector fits in one direction only.
Support 1.800.635.5267
3. Close the latch over the sensor connector. Make
sure the latch is completely closed.

Attach the Sensor to the Patient

Attach the prescribed sensor to the appropriate
location on the patient (for example, finger, forehead,
or foot), as directed by your clinician.
25
PM100N Home Use Guide