Suzuki WagonR+ RB310 Service Manual page 1210

Tooth Contact Pattern
5) After completing of gear tooth contact check, caulk drive
bevel pinion nut (2) with caulking tool (1) and hammer.
Diagnosis and Remedy
NORMAL
HIGH CONTACT
Pinion is positioned too far from the
center of drive bevel gear.
1) Increase thickness of pinion height
adjusting shim and position pinion
closer to gear center.
2) Adjust drive bevel gear backlash to
specification.
LOW CONTACT
Pinion is positioned too close to the
center of drive bevel gear.
1) Decrease thickness of pinion height
adjusting shim and position pinion
farther from gear center.
2) Adjust drive bevel gear backlash to
specification.
These contact patterns indicate that the "offset" of dif-
ferential is too much or too little. The remedy is to
replace the carrier with a new one.
REAR DIFFERENTIAL 7F-17