Suzuki WagonR+ RB310 Service Manual page 1115

7B1-150 AUTOMATIC TRANSAXLE (M13 ENGINE MODEL)
• Install plate snap ring so that its both ends would be posi-
tioned in correct locations as shown in figure.
[A] Correct
[B] Incorrect
• After assembly, measure direct clutch piston stroke.
Special tool
(A): 09900-20607
(B): 09900-20701
Direct clutch piston stroke: 0.4 – 0.7 mm (0.016 – 0.027 in.)
When piston strike is out of specification, select direct clutch
retaining plate with suitable thickness from among the list below
and replace it.
Available direct clutch retaining plate thickness
Thickness
2.8 mm
3.0 mm (0.118 in.)
3.2 mm (0.126 in.)
3.4 mm (0.134 in.)
1. Direct clutch assembly
2. Oil pump assembly
3. Oil hole
Identification mark
4
1
2
3