Suzuki WagonR+ RB310 Service Manual page 1165

7B1-200 AUTOMATIC TRANSAXLE (M13 ENGINE MODEL)
82) Apply A/T fluid to O-rings of each sensor and install input
shaft speed sensor (1) and output shaft speed sensor (VSS)
(2).
Tightening torque
Input shaft speed sensor bolt
(a): 5.5 N·m (0.55 kg-m, 4.0 lb-ft)
Output shaft speed sensor (VSS) bolt
(b): 13 N·m (1.3 kg-m, 9.5 lb-ft)
83) Install harness bracket (3) and select cable clamp (4).
Tightening torque
Harness bracket bolt
(c): 23 N·m (2.3 kg-m, 17.0 lb-ft)
Select cable clamp bolt
(d): 10 N·m (1.0 kg-m, 7.5 lb-ft)
84) Install transmission range sensor to transaxle case, tighten
bolts temporarily at this step.
85) Install lock washer (1) and tighten lock nut (2) to specified
torque.
Tightening torque
Transmission range sensor lock nut
(a): 7 N·m (0.7 kg-m, 5.0 lb-ft)
86) Install manual select lever (1) temporarily at this step.
87) After shifting manual select lever counterclockwise fully,
select "N" range position by bringing it back 2 notches clock-
wise.
88) Remove manual select lever (1) at this step.
89) Loosen sensor bolts (4) and align needle direction shaped
on lock washer (2) with "N" reference line (3) on transmission
range sensor by moving sensor in rotative direction.
90) Tighten sensor bolts (4) to specified torque.
Tightening torque
Transmission range sensor bolt
(b): 5.5 N·m (0.55 kg-m, 4.0 lb-ft)