Suzuki WagonR+ RB310 Service Manual page 772

3
2
(c)
(b)
(a)
1
2
3
(a)
4
5
5) Apply sealant "A" to mating surface of cylinder and cylinder
head and "B" to mating surface of timing chain cover as
shown in figure.
"A": Sealant 99000-31140
"B": Sealant 99000-31250
Sealant amount for timing chain cover
Width "a": 3 mm (0.12 in.)
Height "b": 2 mm (0.08 in.)
6) Apply engine oil to oil seal lip, then install timing chain cover
(1).
Tighten bolts and nut to specified torque.
NOTE:
Before installing timing chain cover, check that pin is
securely fitted.
Tightening torque
Timing chain cover mounting bolt
(a): 25 N·m (2.5 kg-m, 18.0 lb-ft)
Timing chain cover mounting nut
(b): 25 N·m (2.5 kg-m, 18.0 lb-ft)
1
7) Apply engine oil to new O-rings (2) and install them to cap
(3).
8) Install water outlet cap (3) to timing chain cover (1).
Tighten bolts to specified torque.
Tightening torque
Water outlet cap bolt (c): 25 N·m (2.5 kg-m, 18.0 lb-ft)
9) Install new O-ring (1) to oil gallery pipes No.2 (2) and No.3
(a)
(3).
10) Install oil gallery pipes No.2 and No.3 to cylinder head (4)
and timing chain cover (5).
Tighten bolts to specified torque.
Tightening torque
Oil gallery pipes No.2 and No.3 bolt
(a): 11 N·m (1.1 kg-m, 8.0 lb-ft)
ENGINE MECHANICAL (M13 ENGINE) 6A2-37