Suzuki WagonR+ RB310 Service Manual page 1289

5C-12 PARKING AND REAR BRAKE
3) Apply water tight sealant where plate and cable contact, and
run parking brake cable (1) through brake back plate (2) and
secure it with clip (3).
"A" : Sealant 366E, 99000-31090
4) Install wheel cylinder, and tighten wheel cylinder bolts and
brake pipe flare nut to specified torque. (Refer to steps 1) to
4) of WHEEL CYLINDER INSTALLATION in this section.)
5) Install brake shoes, referring to steps 1) to 5) of BRAKE
SHOE INSTALLATION in this section.
6) Install brake drum. Refer to steps 3) to 8) of its INSTALLA-
TION in this section.
7) Fill reservoir with brake fluid and bleed brake system. (For
bleeding operation, see BLEEDING BRAKES in SECTION
5.)
8) Install wheel and tighten wheel nuts to specified torque.
Tightening torque
(a) : 85 N·m (8.5 kg-m, 61.5 lb-ft)
9) Upon completion of all jobs, depress brake pedal with about
30 kg (66 lbs) load at least 10 – 15 times until adjuster actu-
ator clicking sound from drum brake can not be heard so as
to obtain proper drum-to-shoe clearance.
Adjust parking brake cable. (For adjustment, see PARKING
BRAKE INSPECTION and ADJUSTMENT in SECTION 5.)
10) Install console box.
11) Check to ensure that brake drum is free from dragging and
proper braking is obtained. Then remove vehicle from hoist
and perform brake test (foot brake and parking brake).
12) Check each installed part for oil leakage.